Rust Finish Activator rust finish

Rust Finish Activator rust finishrust finish Part 1 rust finish paint Part 2 rust finish activator Part 3 matte sealer Part 1 Stir contents thoroughly before and during use with a broad, flat stirrer, using an upward action, you must mix the iron particles in that may have sunk to the base. Can be brushed or rolled on, can be used over any colour paint if you wish. use a disposable brush preferably not synthetic, apply 2 coats. allow 6 hours between coats, once the second coat is

do not wax

obscure section to ensure suitability

with a touch of burgundy and a little primer red all thrown in together

Easycast accepts a wide range of fillers and can reproduce the most minute detail as a result of its extremely low viscosity

crafting cards

This colour is every hot and fabulous about growing up

Simply mix the wax with a brush

learning to write and draw

brush in circular motion

50mm tungsten carbide tipped (hard metal) double edge blade can be rotated

the crackle finish will start to appear after 30 minutes in the top layer of paint

5 mins / Demould time – 10-20 mins