Nano Docking Station

Nano Docking StationThe Docking Station can charge a fully depleted Nano Beacon in about 12 hours. This givinig up to 15 hours of in water use with a position update rate of once every five seconds. The Nano Docking Stations also allow you to perform an number of tests prior to deployment. These include; current configuration, battery status, initiate power down or wake up, acoustic test signal transmission and firmware update. The System comes with: Nano Docking Charger

2 x Long Hex Standoff

System comes with 4 replacement screws

9") - 250m)

2 x 3-Position Eurostyle Terminal Block

4 x Eurostyle Terminal Strip Mounting Standoffs

On the ROV end of cable are two wet-mateable subsea connectors that connect to the ROV Power Supply Enclosure

It comes standard with a JST GH connector

This aluminium endcap with 14 holes is for use on the 4″ Series Watertight Enclosure

4-10 Screws

and start spooling

1 x 8 GB SD Card Preloaded with Raspbian for ArduSub

The Nano Docking Stations also allow you to perform an number of tests prior to deployment