O2 Fabrication Four Wheel Camper Awning Mounting Brackets 1st Gen Sequoia

O2 Fabrication Four Wheel Camper Awning Mounting Brackets 1st Gen SequoiaOff road gear is only as good as the hardware holding it on. Weve engineered these brackets using 1 8 Stainless Steel, making them impervious to rust and corrosion. The low profile design ensures your awning sits tight to the camper body, minimizing wind noise and snag hazards while maintaining a clean, integrated look. Key Features Zero Drill Installation: These brackets are designed to mount directly to the factory supplied holes on your Four Wheel

Material is Steel

Every switch in this lineup is designed to match the texture

Package includes full front

5 Inch lift Rear Leaf Spring Expansion Pack

ICON Triple Rate rear coil springs for the 2024+ Toyota Tacoma provide a modest increase in ground clearance while greatly enhancing on- and off-road performance

Where other products might look similar

It utilizes a zero-drill mounting footprint that protects your roof line from water ingress while preserving the factory seals if you ever need to remove the assembly

also referred to as air springs

you will need to trim the threaded stud to prevent contact with the camper siding

mitigating the severe highway wind howl typical of traditional top-mounted light bars

spare tire

Rhino Rack and many more offering endless possibilities